Repairing the CB6000 with glue is a popular way to fix the plastic device's very common splitting problems, a problem many people consider a dangerous design flaw. After lots of research on what might work best (thanks so much to all the friends who contributed both on this blog and sol's Fetlife posts ... all your experiences / advice were much appreciated), sol decided to try Epoxy Bond Super Strength, a two part epoxy adhesive that works with most plastics, that dries clear and bonds with maximum strength after 3 days.
Sol used very fine sandpaper on the split and glued inside and out - you can see the glue a bit in the photo above. We gave it the whole weekend to bond.
Sol wore the CB6000 to work yesterday, with a key just in case of irritation from the glue / sandpapering. I didn't want to risk an injury like the last one. It took over a week to heal and left a scar. But his cock seemed fine last night. The glue on the device was not flaking or lifting, as some friends reported, so fingers crossed it might hold.
I left sol out of chastity last night, then relocked the device on him this morning. I again gave him the key, "just in case". I was amused later to see he left the key at home ... hope he didn't have any trouble during the day. He's home now, so I'll go check!
LATER: we had a couple of weeks wear out of the device and then disaster struck again, LOL ... read on here.
(photo: Ms160)
0 comments:
Post a Comment